All FAQs (1753 total: showing 701-720)
- Can a PS100 be charged from a 12 V, 100 Ah battery?
- If a spare PS100 or PS200 is sitting on a shelf, should it be periodically charged?
- Where are the wire leads that plug into a PS100 from a deep-cycle marine battery?
- What size battery is supported for the external battery connection on the PS100? What is the maximum charging rate on the external battery?
- How can it be determined if a PS100 battery is fully charged?
- Can a wall outlet be used to charge the PS100 all the time?
- Can the 0871LH1 be used for either ground-based meteorological applications or in the air (for example, to keep ice off wind turbine blades or the wings of a plane)?
- What happens if the 0871LH1 is covered in ice?
- Using the heater, how long does it take for the 0871LH1 to defrost itself and resume its detection of icing conditions?
- Is it possible to upgrade from PC200W to the current version of LoggerNet?
- After purchasing a LoggerNet upgrade license, can the license key be entered into the current installation, or does LoggerNet need to be reinstalled from the CD?
- After upgrading to the newest LoggerNet version, will the new software run old programs?
- When an upgrade from one version of LoggerNet to another is purchased, can both versions be used at the same time by the same user?
- If the LoggerNet upgrade is purchased for the current version license, how does the upgrade work? What is the process for upgrading?
- What is the difference between a patch and an upgrade for software?
- How can the TCP/IP stack in a CR1000 or CR3000 be used?
- What might cause connection issues between a CR1000 or CR3000 and an NL120, resulting in lost data?
- If several CR1000 or CR3000 dataloggers only have a serial interface that is used as the data highway to a SCADA network, can an NL120 be added without interfering with the current serial port data communications system?
- To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
- If a CR1000 or CR3000 is connected to an NL120 and it has been assigned an IP address, can configuration changes be made on the data logger using only the IP connection?
Previous
Next